FOX-TEK
A wholly owned subsidiary of
Augusta Industries Inc.
Augusta Industries Inc.
FOX-TEK
 

TSXv: AAO

Last Trade: 0.03
Change: Up 0.00
Ask: 0.03
Bid: 0.03
Volume: 15000

Watch our Video Introduction

Marcon International
A wholly owned subsidiary of
Augusta Industries Inc.
 

Use Non-Intrusive Pressure Sensors:

The Challenge

Pressure measurement in pipelines and pressure vessels is a common practice for process control. Tracking pressure fluctuations and maximum pressure levels is essential for structural safety and operational efficiency. Unfortunately, most conventional pressure gages require an opening into the vessel or pipeline so that replacement of the sensor during operations is not possible. Also, since most pressure gages are electrical-based devices, they can pose a hazard when employed in flammable environments.

Is there a pressure sensing system that can be applied to the exterior of a pipe or vessel that is non-intrusive, requiring no drilling of holes or mechanical attachments? Is this system non-electrical and reliable? Can the sensors be applied to any accessible area where direct pressure measurements are required? Can these sensors operate at elevated temperature?

The Solution

FOX-TEK offers fiber optic sensor systems that measure pipe or pressure vessel pressures with high accuracy. The sensors are ideal for operation in flammable environments or in close proximity to electrical equipment because they are passive, non-electrical and immune to electromagnetic interference (EMI). They operate continuously at temperatures as high as 300°C. FT sensors are available in a variety of configurations, and because of their flexibility, are easily bonded to structures of complex curvature. Remote, continuous monitoring or periodic on-site measuring systems are options available to the user with FOX-TEK FT sensor monitors.

Summary of Benefits

Operations
  • Pressure sensors are located directly on the pipe/vessel at points of interest
  • Replacement without drilling access holes in the pipe/vessel
  • Reduced downtime to install pressure sensors
  • Sensors in ground installations will not fail due to lightning strikes
  Cost Savings
  • Reduced installation time
  • Lower fabrication costs for pipes and pressure vessels
  • No mechanical attachment fixtures required
  Safety
  • Sensors are non-electrical and immune to EMI
  • No access ports required ensuring no loss in structural integrity
  Environment
  • No opportunity for leaks to occur at pressure sensor site

Configurations:

RELATED TECHNICAL REPORTS